DESCRIPTION:

CURE-CRETE A is a special blend of resins and aromatic solvents, specifically designed for use as a concrete curing compound, complying to the requirements of A.S.T.M. C309.
CURE-CRETE A is a membrane forming seal which is applied to the surface, to prevent premature evaporation of water and ensure the proper hydration of the surface.
CURE-CRETE A has fast drying solvents which allows treated floors to be used earlier and thus allowing construction to proceed with minimal delay.

TYPICAL USES:

CURE-CRETE A is suitable for use on:
* Concrete Floors
* Precast Concrete
* Concrete Walls
* Concrete Tunnels

ADVANTAGES:

* One part material
* No mixing
* Fast drying
* Ease of application
* Minimizes surface shrinkage of concrete.

SURFACE PREPARATION:

Surfaces to be clean and free of dust, oil, grease and form release agents, can be applied to firm green concrete, having no water ponding areas.

COVERAGE:

It is recommended that the rate of application of CURE-CRETE A be applied between 5 to 6 square metres per litre per coat, generally one coat is sufficient, however this will depend on the porosity of the cement.

APPLICATION:

CURE-CRETE A can be applied by brush or spray. Brush: use a soft bristle brush and work surplus material into the surface. Spray: the application by spray is recommended to ensure an even distribution of material and prevent ponding.

CAUTION:

CURE-CRETE A is highly flammable, keep containers closed when not in use, keep away from heat, sparks or open flame. Avoid application within enclosed areas, use positive fresh air ventilation, avoid breathing vapour or mist, avoid contact with skin and eyes.

PACKAGING:

CURE-CRETE A is available in sealed containers of 20Ltrs and 200Ltrs.

FIRST AID:

If affected by vapour remove from contaminated area. If splashed in eyes, flush with water immediately. If swallowed do not induce vomiting, give plenty water or milk.

The information presented in this data sheet does not imply any warranty. Further, the maker reserves the right to alter the product, the specification and/or the application techniques as described herein without prior notice, in line with his policy of technological advancement and product improvement. Whilst any information and/or specification contained herein is to the best of our knowledge, true and accurate, no warranty is given or implied in connection with any recommendations or suggestions made by us or our Representatives, Agents or Distributors as conditions of use and any labour involved are beyond our control.