PRODUCT DESCRIPTION:

A Liquid Accelerating Admixture for Concrete or Portland Cement mixes.

USES: As an integral set accelerator for concrete and cement mortar.

FEATURES:

Reduced finishing time, especially at low ambient temperatures. Rapid setting and high strengths - 7 days. Improves flow and placing properties. Enables forms to be removed promptly and early use of floor areas.

APPLICATION:

HARD-N-FAST is used as an admixture in concrete to provide reduction of setting time and early development of strength. Reduced setting time may be required because of low ambient temperatures, cement characteristics, construction problems e.g. relief of pressures on formwork or a combination of these.

ADDITION RATES:

Generally used at 2 Lt - 4 Lt per 100kg of cement depending on the sped of acceleration required.

PACKAGING:

20 Litre plastic pails. 200 Litre drums PRECAUTIONS: HARD-N-FAST may be combined with non-metallic aggregate floor hardening materials for hard wearing topping, but should never be used with metallic hardeners such as Ferroflor.

STORAGE:

HARD-N-FAST should not be left on the shelf for longer than 9 months as its effectiveness will be reduced after this time.

The information presented in this data sheet does not imply any warranty. Further, the maker reserves the right to alter the product, the specification and/or the application techniques as described herein without prior notice, in line with his policy of technological advancement and product improvement. Whilst any information and/or specification contained herein is to the best of our knowledge, true and accurate, no warranty is given or implied in connection with any recommendations or suggestions made by us or our Representatives, Agents or Distributors as conditions of use and any labour involved are beyond our control.