DESCRIPTION 

TRU-BOND is a single pack, low viscosity resin solution containing hydrocarbon solvents. 

PURPOSE 

To prime porous and friable surfaces and to promote optimal adhesion of subsequent coats of HI-FLEX membrane and WET-FLEX membrane. 

APPLICATION 

Application is by brush, roller or spray gun. 

SURFACE PREPARATION 

All surfaces must be clean and dry and free from grease and oil, laitance, curing compounds, form release agents and other contaminants. Concrete and cement must be fully cured. Primer should not be applied to external surfaces if it has rained within the last 48 hours. If moisture is suspected in substrate carry out a black rubber mat test. 

CLEAN UP 

Clean up brushes, rollers and equipment in toluol or lacquer thinners. 

PRECAUTIONS

TRU-BOND is flammable and should be used with adequate ventilation and kept away from heat, sparks and open flame. 

SHIPPING IDENTIFICATION 

Resin solution in flammable liquid. Group No. 3 UN No. 1866 HAZCHEM 3YE. FIRST AID If affected by vapour remove from contaminated area. If swallowed do not induce vomiting, give plenty of water or milk. Seek medical attention. If splashed in eyes flush with water immediately. 

PACKAGING 

TRU-BOND is available in sealed 4 litre, 10 litre and 20 litre pails.

The information presented in this data sheet does not imply any warranty. Further, the maker reserves the right to alter the product, the specification and/or the application techniques as described herein without prior notice, in line with his policy of technological advancement and product improvement. Whilst any information and/or specification contained herein is to the best of our knowledge, true and accurate, no warranty is given or implied in connection with any recommendations or suggestions made by us or our Representatives, Agents or Distributors as conditions of use and any labour involved are beyond our control.