DESCRIPTION:

HYDRO-CRETE is a predosed two component composition of white co-polymer latex emulsion and formulated inorganic powder, when mixed exhibits excellent adhesion, compressive, tensile and flexible strengths for waterproofing over a variety of substrates.

PROPERTIES:

HYDRO-CRETE forms a durable, hard wearing, waterproof coating that is unaffected by temperature extremes, sun damage and dilute mineral acids.
HYDRO-CRETE is waterproof when applied in accordance with manufacturer's application instructions.
HYDRO-CRETE is suitable for POTABLE WATER.

ADVANTAGES:

HYDRO-CRETE is environmentally friendly, easy to use, easy to repair and cleans up in water.
HYDRO-CRETE is a cost effective alternative to a variety of products.

PRINCIPAL USES:

HYDRO-CRETE provides an extremely strong coating for a variety of solid external and internal concrete, concrete blocks, asphalt, rolled steel, timber, fibre cement, polystyrene, glass etc. HYDRO-CRETE bonds well to these materials and can be applied in a very thin coat or feathered from thick to thin. Common areas of use are planter boxes, basement walls, podium slabs, concrete tanks, retaining walls, non-slip floors and stairs, restore rain damaged slabs, repair "ponding" surfaces, repair airport pavement, repair parking areas.

SURFACE PREPARATION:

Ensure the surface is free of all dirt, oil, grease, curing compound, form release agents or anything foreign to the natural substrate. In cases of block or brickwork, the joints must be flush finished.

PRIMER: Prime the prepared surface with HYDRO-CRETE Primer at the rate of 8 - 10 sqm per litre by means of a roller or spray. Allow to tack off.

MIXING INSTRUCTIONS: Pour the latex emulsion into a container, add the required mixing water, add the dry powder mix slowly, at the same time mixing with a mechanical stirrer. A slow stirrer such as a festo is suitable.

APPLICATION: To the primed surface apply the mixed HYDRO-CRETE by means of a hopper gun, trowel, squeegee or broom. For waterproofing, apply a minimum of 2mm thick and sponge off while wet.

COVERAGE: Approx. 6 sqm per 30kg unit at a 3 - 4mm application.

PRECAUTION: Do not apply below 10oc or above 32oc or when rain is immanent.

The information presented in this data sheet does not imply any warranty. Further, the maker reserves the right to alter the product, the specification and/or the application techniques as described herein without prior notice, in line with his policy of technological advancement and product improvement. Whilst any information and/or specification contained herein is to the best of our knowledge, true and accurate, no warranty is given or implied in connection with any recommendations or suggestions made by us or our Representatives, Agents or Distributors as conditions of use and any labour involved are beyond our control.